Shrink chuck 4,5° HSK 100 - 10 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Easy to read dial face

bei Ø 6 – Ø 32 mm = h233

For horizontal clamping of flat workpieces

Ausführung:

From DCONWS = 25 on two clamping screws

which prevents the breaking of taps

break-proof and impact-resistant ABS plastic

- Calibration of the angular position of spindles of milling-turning centres

Rotary holder for clamp holders with coolant supply directly to the cutting edge and for ISO clamp holders with claw clamping for optimum cooling of the cutting edge

Hydraulic or manual clamping

With 8mm stem diameter

Without toolholders and inserts