Combi shell mill holder HSK 63 - 27 - 100Application: For mounting milling cutters with transverse or longitudinal groove. Delivery: With retaining screw, driving ring and feather key All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

- Warranty card

For sealing tools with internal cooling

wrench and collets

Bed height H: 0

Measuring contact points are designed to allow measurements near to the bottom of blind holes

PSK = PSK 50

bei Ø 6 – Ø 32 mm = h237

For mounting tools with straight shanks

T-nuts 18 mmTest certificate

Reduction for mounting tools with straightshank

- Calibration of the angular position of spindles of milling-turning centres

Coolant pressure up to 100 bar