Test methods for electrical materials, printed boards and other interconnection structures and assemblies - Measurement of melting temperature or melting temperature ranges of solder alloysWhat is BS EN 61189 11 Melting range of solder alloys about? BS EN 61189 11 is the 11th part of an international standard used for electrical materials, printed boards, and other interconnection structures. By using BS EN 61189 11 you can manufacture good quality solder alloys which are used in electronic equipment. BS EN 61189 11 describes the measurement method of melting ranges of solder alloys that are mainly used for wiring of electrical

System location

Fuse terminal blocks provide direct contact to the conductors by means of edges or points penetrating the insulation

Guiding principles in applying the format

IEEE 1394 interface is present on the product

This results in manufacturing good quality semiconductor sensors

17 apply to water containing less than 100 mg of cyanide per liter

This does not preclude the use of any alarm transmission equipment not covered by one of these specific documents

Requirements are also given for welding

— AL6 – locking plate for pivot pin (see Figure 4 and Table 4)

having joint sizes that are sufficient to obtain cylindrical test specimens with dimensions in accordance with ISO 68921

the influence of moulding conditions and/or different states of the specimens can be assessed without difficulty for all of the properties measured

6 Training