Fibre-reinforced plastic composites. Determination of plain-pin bearingstrength1 Scope This International Standard specifies a procedure for determining the plain pin bearing strength of fibre reinforced plastic composites. The method described in this International Standard is applicable to fibre reinforced plastic composites with either thermoset or thermoplastic matrices.

shrinkage stresses with polyester resin systems can develop at the interface between the topping and the concrete substrate

Note 1: BS 1872 does not specify any requirements for the condition

the provisions of this standard may apply to the superstructure

Included in BS EN 61970-453 are the general use cases for the exchange of diagram layout data

It is applicable to chairs for use by a person weighing up to 100 kg

triticale (Triticosecale Wittmack spp) and feed barley (Hordeum vulgare L

and to the testing of door locks used in association with equipment

providing smoothness and strong grip between pulleys and belts

NOTE Certain Clauses are relevant to component parts of chains and accessories conforming to EN 818‑2:1996+A1

4) calendars

Note: Broad-band command systems are not dealt with in BS 7494-2

expanded and published separately as PD 855468