Pair of Hold down jaws for HP-60 | MP-60Application: For parts with delicate clamping surfaces Jaw parts in contact with the workpiece press the workpiece onto the surface

Surface hardened HRC 58~60

Measuring contact points are designed to allow measurements near to the bottom of blind holes

Setting angle: 95°

For the storage of collet chuck

With clamping screw and O-ring

driving ring and feather key

bei Ø 6 – Ø 32 mm = h235

rack and handles

Suitable for mass production

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

Stahlkörper allseitig geschliffen und gehärtet

Measuring surfaces are carbide