Morse taper adaptor SK 40 - 2 - 50Application: For clamping tools with Morse taper shank and thread according to DIN 228 1 form A. Delivery: With built in tightening bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

bei Ø 6 – Ø 32 mm = h234

For the storage of collets

For the storage of tapping quick change adaptors

For mounting straight-shank tools according to DIN 1835 form B+E

In the tailstock of the lathe so that no friction occurs between the workpiece and the tip

Clamping positions: horizontal and and vertical

Internal measurement jaws are rounded to provide accurate measurement of internal diameters

Only nominal size d can be clamped with sealing plug for internal cooling (applicable up to 21 bar) In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

A complete certificate of calibration traceable to the N

Metric/Inch conversion at any position

Spannkraft voreinstellbar durch Rillenmarkierung

Concentricity: ± 0