Aluminium and aluminium alloys. Drawn wire - Tolerances on dimensionsBS EN 1301 3: 2008 Aluminium and aluminium alloys. Drawn wire. Tolerances on dimensions BS EN 1301 3: 2008 specifies the tolerances on dimensions of aluminium and aluminium alloy drawn wire for general engineering applications (except aeronautical applications), covering diameters, thicknesses or widths or width across flats up to and including 20 mm. BS EN 1301 3 applies to drawn wires, except for electrical or welding purposes , and does not apply

then the principle is given in this document

What is BS EN 12811-2 - Temporary works equipment about

It should be used in conjunction with BS EN 61439-1

BS EN 14620-2:2006 specifies the general requirements for the materials

Interlaboratory tests

voltage unbalance

EN 60086-1:1997

The differences between life-cycle costing and whole-life costing (WLC)

and to adjacent objects

are therefore requested to refer to ISO 6360 in their catalogues

Fire safety departments

In the planning and design of products within the scope of BS EN ISO 8185