End mill holder Weldon SK 50 - 14 - 130Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet

For the transfer of a defined torque

without the illustrated cutting tools

better chip evacuation

Clamping accuracy at the centre 0

M6 - M12 = 10

bei Ø 6 – Ø 32 mm = h235

Stainless steel design

contact- and hot air shrink units

edge radius 1 mm

In NC machines (machines without automatic tool changers)

For mounting drill chucks