Technical product documentation. Representation of splines and serrationsWhat is this standard about? This document specifies the rules and graphical symbols for the representations of splines and serrations in technical product documentation. Two methods of representation are specified: a) complete representation; b) simplified representation. The rules and graphical symbols specified in this document are applicable to detail drawings of parts (shafts and hubs) and to assembly drawings of joints. NOTE For uniformity, all

further guidance is required on how to manage these risks as well as to put them into context with other business risks

1 Components

is essential and is dependent on carrying out an effective risk assessment that identifies the hazard to be faced

addition of the alloy EN AW-5456 in a new Table 38

tile backgrounds

8 Expression of results

plant or structures

The ADSS cable consists of single mode optical fibres contained in one or more protective dielectric fibre optic units surrounded by or attached to suitable dielectric strength members and sheaths

and chimneys about

Manufacturers and suppliers of solar panels

a number of toys are listed which this standard does not apply to

The demand for new reference materials of higher quality is increasing because of both the increased precision of measuring equipment and the requirement for more accurate and reliable data in the scientific and technological disciplines